Also use with "Type W-2" or G.E. "SBM", ITE "C-77", (4 Screw Mounts)
CS-1Hinge is easily added to existing rotary control switches. Installation requires only a few minutes and there is no drilling required, no need to remove the switch from the panel and no disturbing the wiring.
Modify the base to fit 4 screw mounted switches (G.E. "SBM", ITE Type "C-77")
Modify the base to fit the Electroswitch Type "W-2"
Improve your safety procedures and system reliability by using our Rotary Control Switch Safety Cover.
Add Physical Securityto help prevent accidental and unwanted circuit breaker operation.
Enhance your Lockout/Tagout Procedures.
Keep Full 360 degrees visibility.
The CS-1 Hinged Cover cannot be misplaced.
The "CS-1 Hinge" is a "UL recognized component" and can be installed by UL 508 panel shops. (File 480471)
CS-1Hinge is supplied as a two-piece kit. Mounted between the Control Switch escutcheon plate and the panel. Backing off the existing mounting screws far enough to slip the two mounting base pieces under the plate and then tighten the screws once again. Longer screws are supplied if needed. The base piece provides the means to lock the Safety Cover in the closed position.